Menu

Wall Switch Operations

  • Turning the bulb off and then back on will allow you to set the brightness and color temperature without the use of a mobile device or the hub. The bulb will cycle from warm to daylight, and from its lowest brightness to its highest brightness. When it reaches your desired brightness and color temperature, turn it off then on again and it will remember this setting.
  • Turning the bulb off and then back on five times will put the bulb in “Zigbee Network Rejoin Mode”. The bulb will flash two times if successful.
  • Turning the bulb off and then back on seven times will put the bulb in "Zigbee EZ Mode", which allows Zigbee end devices to connect to each other. The bulb will continue flashing for three minutes or until it is turned off.
  • Turning the bulb off and on ten times will factory reset the bulb. The bulbs will flash five times if successful.
Was this article helpful?
>Yes, it was!
>Not really
Great! Thanks for your feedback :)

Can't Find What You're Looking For?

Send us a message